Getting from E to F (Fuel Gauge Problems)

Who thinks about their fuel gauge?  You probably don't… until it doesn't work any more.  Then you have to guess how much fuel is in your tank, and that's no way to live life on the road. 

Fuel gauges, like every other part in your vehicle, can fail.  And when yours stops working, you will probably want to head over to your service facility soon, because no one relishes running out of fuel.

The fuel gauge system is much more than just the gauge you can see on your instrument panel. Most systems have a float inside the fuel tank that goes up and down depending on the fuel level.  It's called the fuel sending unit, and it sends an electrical signal to the gauge (on the dash) telling it to display how much fuel is left in the tank. 

So, what could go wrong?  Well, a few things.  For one thing, corrosion from bad fuel can cause it to stick and it won't move up and down any more.  So you could fill up your tank and the gauge would still read Empty.  If a sending unit needs to be replaced, often the parts can be costly. The good news is that fuel sending units rarely fail and most drivers will never have one go bad.

Other things that can go wrong? An electrical problem could cause a fuse to blow and you won't get a reading at all.  A technician can figure out where that electrical problem is and how to repair it.  Finally, it's possible for the gauge itself (on the instrument panel) to fail.

One thing to keep in mind is if your fuel gauge isn't working, you might be tempted to carry around an extra container of fuel.  That's ok if it's outside the cabin, such as in the bed of a pickup.  But if you carry it inside the cabin or trunk, fuel fumes can be very dangerous for your health, even fatal.

A working fuel gauge gives you peace of mind… so you'll never have that "empty" feeling.

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com

Oh, Stop! (Disc Brake Service)

Every time you drive your vehicle, you wear down your brakes just a little bit.  And after a while, that adds up.  Gradually, your stopping power isn't like it used to be.  Since brakes are one of your vehicle's most important safety features, it just makes sense to keep them performing well.

Most vehicles have disc brakes.  One key component, as the name suggests, is the disc.  Most vehicles have discs on their front and rear wheels.  The discs (also called rotors) are made of metal, and each rotates with the wheel hub.  Your brakes also have pads that make contact with the rotors when you press down on the brake pedal, and the friction stops your vehicle.

After many, many stops, that friction wears down both the pads and the discs and reduces their ability to stop the way you need them to.  The discs may also become uneven from all the heat they generate, and your brakes won't stop as well as they used to when they were newer. 

Some signs that your rotors need attention include vibration at the wheels when you stop, discolored rotors (the metal looks blue), excessively hot rotors, or grooves in the metal.  If you see any of these signs, it's time to bring in your vehicle for us to inspect your brakes. 

A technician will measure the thickness and trueness of the rotors and check the surfaces for wear.  If they need to be replaced, they'll be done in pairs, so if a front rotor is bad, the other front rotor will also be replaced. Usually, your brake pads will be replaced at the same time.  You can ask your service advisor if higher-performance brakes would benefit you.

When your vehicle is at the shop, the technician will check other components of your brake system to make sure they are operating safely. Brakes are vital to the safe operation of your vehicle.  Keep them well maintained so they can be there when you need them.

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com

Service to Improve Fuel Economy

The price of gas in ON has got people in Burlington talking. It seems that Burlington folks who need a bigger vehicle to carry family and gear, or provide four wheel drive, are hit especially hard. That is why we thought it would be good to review some things that anyone can do to improve fuel economy.

First let's start with how we drive around ON. People in Burlington may not realize that they can really save on gas by just changing a few driving habits. One of the biggest is jackrabbit starts - you know, flooring the gas as soon as the light turns green. That really wastes a lot of fuel. Building up your speed at a slower pace uses less fuel and is easier on your engine and drive train. And don't drive with one foot on the brake. That's also a drag on fuel economy, and it wears out your brakes faster, too.

Another thing Burlington drivers can do is drive more slowly - but only when it's safe. Sometimes on the freeway we drive an extra five ... ten . . . twenty ... over the speed limit. We do it to save time, but it only saves a few minutes out of maybe an hour long drive, and we may use 10 to 15 % more gas. Just leave a little bit earlier, save some money and arrive more relaxed.

Burlington drivers can also try and combine all of their errands for the day into just one trip, rather than several. If you can put off a trip today that can be combined with one tomorrow, you can save some time and money.

Using your cruise control can save money too. Driving in ON at a constant speed really improves fuel economy. Be sure to only use your cruise control under safe conditions; you can look in your owner's manual for some good tips on using your cruise control.

Did you know that reducing the weight in your vehicle saves gas? Clean out the trunk or back seat from time to time so that you are not paying to carry a lot of stuff around Burlington that you do not need in the vehicle. If you live in ON where there is snow and ice, clear it off your vehicle; it adds weight and messes with aerodynamics too.

Another tip is to avoid long idle times, which includes warming it up when you start. Modern engines do not require a long warm up to get going;  just take it easy for a few minutes.

Be sure to get a new gas cap if yours leaks or is worn.

Now, let's start talking mechanical. Bottom line - the better you maintain your vehicle, the less fuel you will use. It all adds up in a big way. For example, replacing your dirty engine air filter will pay for itself in improved fuel economy before your next oil change - and will keep saving you after that.

A clean, well-maintained fuel system really pays big dividends. A clogged fuel filter wastes gas. So does a dirty fuel system, grimy fuel injectors and plugged up PCV valves. A fuel system service decreases the gas you use, and increases the power, so drivers in Burlington can't go wrong with that.

Some of us ignore our Check Engine light. But fixing the problem that caused the light to come on will usually save some fuel as well. It may be a bad oxygen sensor that can really rob your fuel economy.

And, it may be time for a tune-up. Tune-ups should improve your fuel economy. Don't overlook the routine maintenance items, like scheduled oil changes, transmission and cooling system service. Dirty or low fluids actually use more fuel. Just look at your vehicle manufacturer’s recommended service intervals in the owner's manual, or ask your Corporate Autoworks service advisor for the schedule.

Don't forget your tires. Underinflated tires waste gas. And if your wheels are out of alignment, you won't get the fuel economy you need.

None of these things are very complicated or expensive for people in Burlington to stay on top of. When you maintain your car properly, you save gas today and prevent repairs tomorrow.

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com

Alternator Facts (Failing Alternator)

If you notice that your headlights are flickering at night, that's something to pay attention to. While there could be many different things that could cause that problem, one possibility is your vehicle's alternator.

The alternator takes mechanical energy from the engine and turns it into electricity, in essence a generator.  The current it makes charges the battery and supplies power to the vehicle's electrical systems.  An alternator is made up of several different parts: a pulley, magnets, coil wires, brushes and a voltage regulator.  While your vehicle is running, these parts get a good workout and, after time, they begin to wear out.

Other symptoms of a failing alternator include your vehicle's lights dimming, the power windows going up and down more slowly than they used to, your power seats not moving quite as fast as before. 

Another sign of a worn out alternator is engine stalling.  Vehicles with fuel injection require a certain amount of power, and when an alternator is going bad, your engine could stall because the alternator isn't cranking out enough of it.

An alternator on its last legs can also fail to charge your battery properly.  Sometimes your battery isn't getting enough charge from the alternator and will go dead.  It also can be the opposite problem. The battery is getting too much power and will cause the battery to get hot.  Your vehicle may give you a clue on the instrument panel.  If you see any of these warning lights, take note: Check Engine, ALT, CHARGE or one that looks like a picture of a battery.  If that light is on, it's time to have your service facility give it a look.

As mentioned earlier, there are other components of your vehicle's electrical system that can fail, such as a worn out serpentine belt or a malfunctioning voltage regulator.  A reputable service facility has diagnostic tools to pinpoint the causes of your problems. And when your issues are fixed, your electrical system will be back to its hard-working self.  You'll get a real charge out of it!

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com

I Can See Clearly (Wiper Blade Replacement)

Warm weather can bring severe storms, and when the rain is coming down hard, that's one time you really need to be able to see as clearly as possible out your windshield.  Having wiper blades that are fit for the job are important to maintain that safe view.

Maybe you live in a climate where you use blades made for winter weather and you have haven't changed them since the weather changed.  Those blades are made of heavier materials and don't work as well in warmer temperatures. Blades made for warm temperatures are lighter and clear water better in the warmer months.

The general rule of thumb is you should change your blades every six months, but if you use them a lot, you might have to change them more often.  A couple of signs that your blades need changing? If you are seeing streaks on the glass or hearing a chattering sound when your wipers are working, time for a new pair.

Wiper blades have cleaning windshields on vehicles for more than 100 years.  The original designs have a multi-part frame that are better for flatter windshields.  But newer vehicle designs now have curvier windshields, so a more recent design is called a blade wiper.  It's designed to conform better to the glass so cleans it better. 

Conventional wipers also aren’t as aerodynamic as blade wipers. Wind buffeting can reduce the pressure they apply on the rubber to the glass.  With a spoiler as part of their design, blade wipers are pressed more tightly to the glass, an advantage in clearing water from it.

Another option is hybrid blades, essentially a conventional blade with a plastic shell around the wiper's frame that makes it more aerodynamic and, some say, gives it a more aesthetic look. 

There are lots of choices, so consult our service professionals for a recommendation on which blade fits your needs—and budget—best.  Keep your eyes on the road and keep your windshield sparkling clean, rain or shine.

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com