Always on Guard (TMPS)

One of the most important things you can do to keep your vehicle running safely is to make sure your tires are properly inflated.  If one or more is vastly over- or underinflated, that has the potential to cause major handling problems and may result in a dangerous accident.

All vehicles in recent years are equipped with Tire Pressure Monitoring Systems, or TPMS.  One system uses small sensors in the tires that continually check the pressure in each tire.  That sensor sends a signal to computers in your vehicle which turns on an instrument panel light warning of low pressure when at least one is very low. Or it may update a numeric reading on your instrument panel which gives you an approximation of how many PSI (pounds per square inch) of air is in each tire. 

Another system works with your antilock brake system to measure the size of your vehicle’s tires.  When one wheel is going faster than another, it will spin faster. A computer sees that and alerts you that tire’s diameter is smaller than the others and therefore must be underinflated.

No matter what system you have, it’s also helpful for you to know how much pressure each tire is supposed to be inflated to.  You can find that on a label on the driver’s side door sill. In addition, the TPMS system should not be used as a substitute for checking your tires with a tire gauge since the TPMS accuracy usually isn’t quite as precise.  Keep in mind that tire sensors can fail, so each system acts as a backup for the other. 

Since many vehicles these days don’t have spare tires, it’s good to know that your TPMS can warn you if you have a leak in one of your tires.  If you get a low-pressure warning, many systems will tell you which tire is low, so you can do your own visual check.  Often you can see if you’ve picked up a nail or a screw if it’s sticking out of the tread or near the sidewall.

Being able to receive an early warning from your vehicle of abnormal tire pressure may give you a chance to safely drive to a service center before your tire slowly goes completely flat (which can ruin the tire and badly damage the rim). It also may ultimately prevent you from being stranded somewhere with a flat tire or, most importantly, having a sudden blowout on the road. 

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com

Fuel Saving Tip: Fuel System Cleaning Near Burlington, ON

A lot of fuel is wasted in the Burlington area by dirty fuel delivery systems in vehicles.

Let's start at the tank. The gas tank gathers dirt, rust and sediment over the years. That's why there's a fuel filter to clean the fuel after it leaves the tank. A dirty filter will rob the engine of the clean gas it needs to run efficiently.

The fuel intake components get coated with gum and varnish over time. This results in fuel being delivered inefficiently and some of that gunk getting into the engine. A fuel system service at Corporate Autoworks will leave your intake components as clean as a whistle.

The big fuel thief is dirty fuel injectors. They deliver fuel to the engine at a specified pressure and in a particular spray pattern. When they're clogged, the fuel doesn't get atomized the way it's supposed to and doesn't get burned as efficiently.

See your owner's manual or ask your Burlington service advisor at Corporate Autoworks when a fuel system cleaning is recommended.

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com

Not Too Hot and Not Too Cold (Temperature Gauge)

You know your body temperature is supposed to be 98.6 degrees F, 37 degrees C.  Your vehicle has a normal temperature, too, and if you pay attention to it, that can save you some big headaches down the road.

Many vehicles have a temperature gauge on the dash that takes the temperature of the engine's coolant.  Some have a thermometer symbol, some read C-H (cold to hot). Many will have a red zone that shows when water temperature is getting into the danger zone.  Others are digital and have a red warning light that signals overheating.  And some vehicles have a light that goes on when the engine temperature is out of the normal range.

If your vehicle has a gauge, pay attention to it.  If you need help locating it, ask one of our Corporate Autoworks experts to give you a quick explanation.  Chances are when the vehicle has been running for 15 minutes or more, the temperature gauge will settle into its own "normal" zone, often just below the midway point.  If you have a digital readout, remember what that "normal" temperature is.  Here's why.

At any point when you're driving, the temperature gauge is the quickest way to get a sense that the engine is running the way it should, a quick health checkup, as it were. Say you're on a 3-hour trip, glance at that gauge every hour or so.  It should always be in the same spot.  If it starts to move one way or the other, you may be able to catch a problem before it gets serious.

Pay special attention to it moving into the hot zone.  The needle on the gauge is the easiest and least distracting way to see an engine heating up, but on a digital gauge, start paying attention if the temperature reaches 240ºF/115ºC or more.

Remember, though, that just because the gauge reads "hot" doesn't mean your engine is on the verge of burning up.  It could be a bad sensor and the engine will be at a normal temperature.  But it also could be a failing water pump, coolant leak or thermostat.  By pulling off the road and observing your engine, it will give you a pretty good idea if it's running hot or not.

If the gauge is too "cold," it could be a broken gauge or thermostat sticking open.  Usually being in the cold range isn't as worrisome, but you should have it checked out since other systems may be affected.

Heat is one of a vehicle's worst enemies, especially when it comes from within.  Know your vehicle's normal temperature and keep an eye on it.

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com

For Brakes' Sake (Brake Rotor Service in Burlington)

Think of how much abuse your brakes take. Day in and day out, they stop your vehicle when it's going fast and when it's going slow. Maybe your vehicle has been vibrating when you brake, or maybe it seems like your stopping distance is a little bit longer than it used to be.

Then it's time to get your brakes checked out. After all, you have to be able to stop if you want to be safe. Nearly all newer vehicles have disc brakes on the front, and many have that type of brake on all four wheels. That makes it likely you'll be getting disc brakes fixed at some time in your vehicle's lifetime.

Knowing how disc brakes work is as easy as riding a bicycle. If your bike had hand brakes, you'll probably remember a mechanism that squeezed a couple of pads on each side of your bicycle wheel when you applied the brakes. Disc brakes are similar; but instead of the bike wheel, there's a metal disc instead. If that disc is warped or has irregularities in it, it's going to vibrate.

It used to be that rotors were thick, and when they warped, a technician could "turn" them to scrape off a layer of metal so their sides were straight again. The latest vehicles are using thinner, lighter rotors with a slightly different construction. Now, it's likely that rotors that are resurfaced this way will not have enough metal left to work safely. In fact, some manufacturers advise only replacing rotors that are worn out.

Newer designs have reduced rotor prices, and in many cases, the labor cost of turning the rotors is higher than buying new. There are times, though, where your rotors can be resurfaced and still meet manufacturer specifications.

If you have a rotor replaced on one side of your vehicle, it might be a good idea to replace rotors on the other side, too.

Maybe you're looking for the new rotors to last longer than the ones that were on there. New technologies can offer a longer lifespan in a premium rotor. Armed with knowing the type of driving you do, you and your Corporate Autoworks service advisor can make the best decision on which direction you want to go with your new brakes.

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com